Nice to join in.
While my Ranger is only a 2.2 it does the job.
But, i would like some lighting assistance please .
I was wondering how can i tap into the wire which feeds the white (courtesy) LEDs on the rear high brake light so I can add a LED light under my canopy lid.
I thought there might be a loom near the right rear passenger door before it feeds up to the light and i can jumper from there.
I was going to go off the dash mounted switch but it seems to be part of a CANBUS system?
Could any of you legends supply a wiring loom schematic or any info please for a 2016 XT ranger.