Page 1 of 1

Hi, First ranger. 🙂

Posted: Mon Apr 05, 2021 9:47 pm
by Jman71
Hi, purchased my first Ranger, ticks all the boxes for my needs. Looking for advice regarding front recovery points.
Not a fan of Road safe recovery points due to how low they hang. My Ranger has a Ford factory bullbar. Looked at fitting a set of UNeek recovery points, which would have been great except unfortunately the main bolt holding bullbar on chassis is to large to go thru uneek r/p bolt hole. Open to suggestions. Thank you.

Re: Hi, First ranger. 🙂

Posted: Tue Apr 06, 2021 1:40 pm
by Bill68
id recomend you buy a second hand TJM bar and sell that one

Re: Hi, First ranger. 🙂

Posted: Tue Apr 06, 2021 3:09 pm
by lincolnland
Or buy the drivers side roadsafe recovery point and use an equalizer strap from the oem point to the roadsafe point. There is 1 for sale in the for sale section

Re: Hi, First ranger. 🙂

Posted: Tue Apr 06, 2021 9:20 pm
by Komang
Road safe defenetly will fit with original bullbar

Re: Hi, First ranger. 🙂

Posted: Wed Apr 07, 2021 1:48 pm
by Simonj13
These are the ones I have. Follow the shape of the OEM point.
https://www.medicar.com.au/4WD-Fit-outs ... ery-Points

Re: Hi, First ranger. 🙂

Posted: Mon Apr 12, 2021 8:47 pm
by Jman71
Thanks for feedback. Will check out the Medicar points.