2019 bi turbo wildtrak build

A Place To Show Off Your Ranger Photo's
Post Reply
nooffence1
Member
Posts: 4
Joined: Thu Sep 19, 2019 10:52 am

2019 bi turbo wildtrak build

Post by nooffence1 »

This is my first ranger, had it for 9 months now. Wanting to do some touring probably next year. Cape York trip is on my bucket list so want to get it setup for that.

2inch ironman lift kit
285/65r18 BFG KO2
Tradie Rhino platform with backbone and wind deflector
Custom made snorkel by pilly's custom fabrication
Ironman barwork all around
Attachments
pic3.jpg
pic2.jpg
pic1.jpg
jezalenko
Member
Posts: 20
Joined: Tue Nov 26, 2019 9:35 pm

Re: 2019 bi turbo wildtrak build

Post by jezalenko »

Looks mint! What rims have you put on, and what offset are they?
nooffence1
Member
Posts: 4
Joined: Thu Sep 19, 2019 10:52 am

Re: 2019 bi turbo wildtrak build

Post by nooffence1 »

18x9 +25 monster artillery
blueshine
25 Club
Posts: 37
Joined: Wed Jul 10, 2019 8:07 pm

Re: 2019 bi turbo wildtrak build

Post by blueshine »

Was the wind deflector put on with the platform or added later? If you ran with and without does it make any difference to the wind noise and fuel consumption?
nooffence1
Member
Posts: 4
Joined: Thu Sep 19, 2019 10:52 am

Re: 2019 bi turbo wildtrak build

Post by nooffence1 »

I bought it separately. Wind noise was improved slightly. Still noisy though. I had droning at 100ish and it helped with that.

Still not sure if it was worth it, I should take it off and see if it's a big difference.

Didn't run without one long enough to notice if there was a difference in fuel economy.
blueshine
25 Club
Posts: 37
Joined: Wed Jul 10, 2019 8:07 pm

Re: 2019 bi turbo wildtrak build

Post by blueshine »

Thanks, that's helpful to know.
Daveyboygreen
Member
Posts: 1
Joined: Sat Jul 18, 2020 9:13 am

Re: 2019 bi turbo wildtrak build

Post by Daveyboygreen »

Looks good! Did you have any problems fitting the 285/65s, any cutting or rubbing?
nooffence1
Member
Posts: 4
Joined: Thu Sep 19, 2019 10:52 am

Re: 2019 bi turbo wildtrak build

Post by nooffence1 »

No rubbing issues. Didn't have to cut anything.
Post Reply